Horse Weight Calculator

Use this horse weight calculator to estimate your horse's weight from two tape measurements — heart girth and body length — without a weighbridge. Enter the measurements in inches or centimetres and get the weight in pounds and kilograms, ready to use for feed rations, wormer doses and trailer planning. It takes under a minute, with a tape measure you already own.

Close-up of a horse wearing a bridle — heart-girth and body length measurements estimate its weight

Calculate your horse's weight

Around the barrel, just behind the elbows and the withers slope.

From the point of the shoulder to the point of the buttock.

Estimated weight

1,037 lb

Weight in pounds1,037 lb
Weight in kilograms470 kg
Estimated weight1,037 lb (470 kg)

An estimate from the standard weight-tape formula, not a scale reading. Measure twice and use the average if the two readings differ.

Use this weight in the feed calculator · Plan hay for this weight

Why knowing your horse's weight matters

Almost every feeding decision starts with body weight. Forage and feed are rationed as a percentage of body weight — most horses eat roughly 1.5 to 2.5 per cent of their weight in forage each day — so a ration built on a guessed weight can be hundreds of pounds of hay a month out. Knowing the weight turns the ration from a habit into a plan, and it is the figure our feed and hay tools both start from.

Dosing is the second reason. Wormers, and many medicines your vet prescribes, are dosed by weight bands: under-dose a wormer and it may not work properly, which also encourages resistant worms; over-dose and you waste money at best. The third reason is safety on the road. Horse, tack, hay and passengers all count against a trailer and tow vehicle payload, and that total starts with an honest figure for the horse itself.

How to measure heart girth and body length

Stand the horse square — all four feet evenly placed — on level ground, ideally before feeding, and use a soft tape measure. Two measurements are all the formula needs:

Heart girth (A). Pass the tape around the barrel immediately behind the elbows, following the slope of the withers, so the tape sits in the girth groove. It should be snug, not tight, and the reading is taken as the horse breathes out. Keep the tape vertical and flat against the coat, without twisting.

Body length (B). Measure in a straight line from the point of the shoulder to the point of the buttock — the furthest point of the hindquarter. This is the step most often done wrong: the tape should bridge straight between the two points, not follow the curve of the shoulder and hindquarter around.

Measure both twice. If the readings differ, re-measure rather than averaging a mistake away; two matching readings are the sign the tape was in the right place. The diagram below shows both lines on the horse.

B — body lengthA — heart girth
A: heart girth, around the barrel just behind the elbows. B: body length, point of shoulder to point of buttock, measured straight.

The weight-tape formula

This is the standard weight-tape formula, published in full on our methodology page. In imperial units: weight in pounds equals heart girth in inches, squared, multiplied by body length in inches, then divided by 330. In metric units: weight in kilograms equals heart girth in centimetres, squared, multiplied by body length in centimetres, then divided by 11,880. The two constants are not magic numbers: each converts a volume-like measurement — girth squared times length — into a typical horse's mass. Switch the units in the calculator and it converts your result as well, at one pound to 0.4536 kilograms.

Worked example: a riding horse, in both units

Take a riding horse measuring 72 inches around the heart girth and 66 inches long. Squaring the girth gives 5,184; multiplied by the length that is 342,144; divided by 330, the estimate is 1,037 pounds, about 470 kilograms. The same formula worked in metric looks like this:

Imperial: heart girth72 in
Imperial: body length66 in
Imperial: calculation(72² × 66) ÷ 330
Imperial: estimated weight1,037 lb (≈470 kg)
Metric: heart girth180 cm
Metric: body length170 cm
Metric: calculation(180² × 170) ÷ 11,880
Metric: estimated weight464 kg (≈1,023 lb)

Run your own two measurements above — the result links carry the weight, in kilograms, straight into the feed and hay calculators, so you only measure once.

How accurate is the estimate?

For an average-built horse in moderate condition, the formula typically lands within a few percent of a scale weight — close enough for setting a ration, choosing a wormer dose band and checking a trailer load. It is still an estimate. The formula assumes a typical shape, so it is less accurate for ponies, who are rounder for their length, for heavy drafts, for mares in late pregnancy, and for very fit, flat-sided horses whose barrel the tape reads small. Condition matters too: a fat horse and a fit horse with the same measurements do not weigh the same in the way the formula expects. Use the result as a planning figure, track it over time, and treat a weighbridge or livestock scale as the exact answer when a decision — a precise drug dose, a borderline payload — depends on it.

Put the weight to work

Once you have a weight you trust, size the daily ration with our feed calculator, plan bales with the hay calculator, or check a youngster against the age calculator. Every method and source behind these tools is published on our methodology page, and the University of Minnesota Extension's horse care and management resources are a sound companion read on condition and feeding.

Horse weight questions

How accurate is the horse weight formula?

For an average-built horse it usually lands within a few percent of a scale weight — close enough for rationing, dosing bands and load planning. Shape matters too, so very fit, flat-sided horses, heavy drafts and mares in late pregnancy can sit further from the figure. When a decision needs an exact weight, use a weighbridge.

Where exactly do I measure heart girth and body length?

Heart girth goes around the barrel immediately behind the elbows, following the slope of the withers, snug but not tight. Body length runs straight from the point of the shoulder to the point of the buttock, not around the body's curve. Stand the horse square on level ground and measure twice.

Does the formula work for ponies and draft horses?

It gives a usable estimate for most ponies and light draft types, but it is least accurate at the extremes: ponies are often rounder for their length, and heavy drafts carry more mass than the tape captures. Treat it as a starting figure, and prefer a scale weight for dosing or transport decisions.

How often should I weigh my horse?

Every two to four weeks suits a horse in regular work, and whenever condition visibly changes — a new yard, a season change, a change in work or feed. Weigh at the same time of day, before feeding, so figures stay comparable. The trend matters most: a steady drift signals it is time to adjust feed.

Is a weight tape or the formula better?

A weight tape converts heart girth alone into a weight printed on the tape. The formula adds body length, so it usually tracks real weight more closely across different builds. A tape is quicker for a weekly check; the formula is better when the number will drive a ration, a dose or a load.